81 lines
2.0 KiB
Markdown
81 lines
2.0 KiB
Markdown
# Sharp Memory LCD Kernel Driver
|
|
|
|
**Note**: I did not write this driver. I only modified it to clean up compiler warnings/errors. The original can be found here:
|
|
(http://www.librecalc.com/en/wp-content/uploads/sites/4/2014/10/sharp.c)
|
|
|
|
More information can be found here:
|
|
(http://www.librecalc.com/en/downloads/)
|
|
|
|
This driver is for the LS027B7DH01. It *should* work with other Sharp Mem LCD displays by modifying all 400/240 references with the correct dimensions for your screen.
|
|
|
|
## Hookup Guide
|
|
Connect the following pins:
|
|
|
|
Display | RasPi
|
|
------- | ---------
|
|
VIN | 3.3V
|
|
3V3 | N/C
|
|
GND | GND
|
|
SCLK | 11 (SCLK)
|
|
MOSI | 10 (MOSI)
|
|
CS | 23
|
|
EXTMD | 3.3V
|
|
DISP | 24
|
|
EXTIN | 25
|
|
|
|
## Compile/Install the driver
|
|
Verify that you have the linux kernel headers for your platform. For the RasPi these can be obtained by:
|
|
```
|
|
sudo apt-get install raspberrypi-kernel-headers
|
|
```
|
|
or more generally:
|
|
```
|
|
sudo apt-get install linux-headers-$(uname -r)
|
|
```
|
|
|
|
To compile the driver, run:
|
|
```
|
|
make
|
|
```
|
|
|
|
To install the driver, run:
|
|
```
|
|
sudo make modules_install
|
|
```
|
|
|
|
If you want the module to load at boot you'll need to add it to the /etc/modules file, like:
|
|
```
|
|
...
|
|
# This file contains...
|
|
# at boot time...
|
|
sharp
|
|
```
|
|
|
|
## Compile/Install the Device Tree Overlay
|
|
The included sharp.dts file is for the Raspberry Pi Zero W. To compile it, run:
|
|
```
|
|
dtc -@ -I dts -O dtb -o sharp.dtbo sharp.dts
|
|
```
|
|
|
|
To load it at runtime, copy it to /boot/overlays:
|
|
```
|
|
sudo cp sharp.dtbo /boot/overlays
|
|
```
|
|
|
|
And then add the following line to /boot/config.txt:
|
|
```
|
|
dtoverlay=sharp
|
|
```
|
|
|
|
## Console on Display
|
|
If you want the boot console to show up on the display, you'll need to append `fbcon=map:10` to /boot/cmdline.txt after *rootwait*, like:
|
|
```
|
|
... rootwait ... fbcon=map:10
|
|
```
|
|
|
|
To make sure the console fits on screen, uncomment the following lines in /boot/config.txt and set the resolution appropriately:
|
|
```
|
|
framebuffer_width=400
|
|
framebuffer_height=240
|
|
```
|