Kevin Townsend ce75a21e50 Revert "Supervisor REPL support for ports/nrf/boards/feather52"

This reverts commit 92113dde81.

2017-11-23 13:38:38 +01:00

3.1 KiB

Raw Blame History

Setup

Before you can build, you will need to run the following commands once:

$ cd circuitpython
$ git submodule update --init
$ make -C mpy-cross

You then need to download the SD and Nordic SDK files:

This script relies on wget, which must be available from the command line.

$ cd ports/nrf
$ ./drivers/bluetooth/download_ble_stack.sh

Building and flashing firmware images

Building CircuitPython

REPL over UART (default settings)

To build a CircuitPython binary with default settings for the feather52 target enter:

$ make BOARD=feather52 V=1

REPL over BLE UART (AKA `NUS`)

To build a CircuitPython binary with REPL over BLE UART, edit bluetooth_conf.h with the following values (under #elif (BLUETOOTH_SD == 132)):

#define MICROPY_PY_BLE                  (1)
#define MICROPY_PY_BLE_NUS              (1)
#define BLUETOOTH_WEBBLUETOOTH_REPL     (1)

Then build the CircuitPython binary, including SD=s132 to enable BLE support in the build process:

$ make BOARD=feather52 V=1 SD=s132

Flashing with `nrfutil`

The Adafruit Bluefruit nRF52 Feather ships with a serial and OTA BLE bootloader that can be used to flash firmware images over a simple serial connection, using the on-board USB serial converter.

These commands assume that you have already installed nrfutil, as described in the learning guide for the Arduino variant of the board.

1. Update bootloader to single-bank version

The Adafruit nRF52 Feather ships, by default, with a dual-bank bootloader that cuts the available flash memory in half in exchange for safer OTA updates.

Due to the size of CircuitPython, we must migrate this bootloader to a single-bank version, doubling the amount of flash memory available to us.

These commands only need to be run once and will update the SoftDevice and bootloader from the dual-bank version that ships on Arduino-based Adafruit Feather52 boards to a single-bank CircuitPython compatible version:

S132 v2.0.1 single-bank (recommended):

By default s132 v2.0.1 is used when no SOFTDEV_VERSION field is passed in:

$ make BOARD=feather52 SERIAL=/dev/tty.SLAB_USBtoUART boot-flash

S132 v5.0.0 (BLE5, experimental):

To enable BLE5 support and the latest S132 release, flash the v5.0.0 bootloader via:

$ make BOARD=feather52 SERIAL=/dev/tty.SLAB_USBtoUART SOFTDEV_VERSION=5.0.0 boot-flash

2. Generate a CircuitPython DFU .zip package and flash it over serial

The following command will package and flash the CircuitPython binary using the appropriate bootloader mentionned above.

This command assumes you have already build a valid circuitpython image, as described earlier in this readme.

The name of the serial port target will vary, depending on your OS.

$ make BOARD=feather52 SERIAL=/dev/tty.SLAB_USBtoUART dfu-gen dfu-flash

If you built your CircuitPython binary with BLE UART support you will need to add the SD=s132 flag as shown below:

$ make BOARD=feather52 SERIAL=/dev/tty.SLAB_USBtoUART SD=s132 dfu-gen dfu-flash

3.1 KiB Raw Blame History