Also contains raw memory read/write functions, read8, read16, read32,
write8, write16, write32. Can now do:
stm.write16(stm.GPIOA + stm.GPIO_BSRRL, 1 << 13)
This turns on the red LED.
With the new constant folding, the above constants for the GPIO address
are actually compiled to constants (and the addition done) at compile
time. For viper code and inline assembler, this optimisation will make
a big difference. In the inline assembler, using these constants would
not be possible without this constant folding.
All board config macros now begin with MICROPY_HW_.
Renamed PYBv10 to PYBV10, since macros should be all uppercase.
Made SDCARD_DETECT configurable in mpconfigport.h, so that the SD
detect pin can be easily configured.
Can now choose at boot up whether the USB device is CDC+MSC or CDC+HID.
Choice is made by an option in boot.py, with default being CDC+MSC.
HID+MSC is not currently supported, but should be easy to implement.
Boot up now has ability to change the reset mode: hold down USR switch
while booting and LEDs will count from 1 to 7 to indicate the boot mode.
Release USR when correct mode is selected. Current modes are 1 (normal
boot), 2 (safe mode), 3 (reset FS mode).
Added support for the ADC channels and mappings to make_pins.py
I'm not sure if the hal properly deals with the channel 16/18 differences
between the 40x and 42x. It seems to deal with it partially. This particular
aspect will need testing on a 42x or 43x.
New USB HAL is quite a bit improved over previous one. Now has better
callbacks and flow control.
REPL over USB CDC now works as before, except for soft-reset (since USB
driver uses malloc...).
