circuitpython/ports/atmel-samd/boards/metro_m0_express/mpconfigboard.h

45 lines
1.4 KiB
C
Raw Normal View History

#define MICROPY_HW_BOARD_NAME "Adafruit Metro M0 Express"
#define MICROPY_HW_MCU_NAME "samd21g18"
//#define MICROPY_HW_LED_TX &pin_PA27
//#define MICROPY_HW_LED_RX &pin_PA31
#define MICROPY_HW_NEOPIXEL (&pin_PA30)
// Clock rates are off: Salae reads 12MHz which is the limit even though we set it to the safer 8MHz.
#define SPI_FLASH_BAUDRATE (8000000)
#define SPI_FLASH_MOSI_PIN &pin_PB22
#define SPI_FLASH_MISO_PIN &pin_PB03
#define SPI_FLASH_SCK_PIN &pin_PB23
#define SPI_FLASH_CS_PIN &pin_PA13
// These are pins not to reset.
#define MICROPY_PORT_A (PORT_PA24 | PORT_PA25 | PORT_PA30 | PORT_PA31)
#define MICROPY_PORT_B (0)
#define MICROPY_PORT_C (0)
// If you change this, then make sure to update the linker scripts as well to
// make sure you don't overwrite code.
#define CIRCUITPY_INTERNAL_NVM_SIZE 256
#define BOARD_FLASH_SIZE (0x00040000 - 0x2000 - CIRCUITPY_INTERNAL_NVM_SIZE)
#define BOARD_HAS_CRYSTAL 1
2018-05-15 15:33:27 -04:00
#define DEFAULT_I2C_BUS_SCL (&pin_PA23)
#define DEFAULT_I2C_BUS_SDA (&pin_PA22)
2018-05-16 15:36:36 -04:00
#define DEFAULT_SPI_BUS_SCK (&pin_PB11)
#define DEFAULT_SPI_BUS_MOSI (&pin_PB10)
#define DEFAULT_SPI_BUS_MISO (&pin_PA12)
2018-05-17 13:48:33 -04:00
#define DEFAULT_UART_BUS_RX (&pin_PA11)
#define DEFAULT_UART_BUS_TX (&pin_PA10)
// USB is always used internally so skip the pin objects for it.
#define IGNORE_PIN_PA24 1
#define IGNORE_PIN_PA25 1
#define CIRCUITPY_I2CSLAVE