circuitpython/ports/atmel-samd/boards/circuitplayground_express/mpconfigboard.h

#define MICROPY_HW_BOARD_NAME "Adafruit CircuitPlayground Express"
#define MICROPY_HW_MCU_NAME "samd21g18"

// Don't allow touch on A0 (PA02), because it's connected to the speaker.
#define PA02_NO_TOUCH       (true)

// Salae reads 12mhz which is the limit even though we set it to the safer 8mhz.
#define SPI_FLASH_BAUDRATE  (8000000)

// On-board flash
#define SPI_FLASH_MOSI_PIN          &pin_PA20
#define SPI_FLASH_MISO_PIN          &pin_PA16
#define SPI_FLASH_SCK_PIN           &pin_PA21
#define SPI_FLASH_CS_PIN            &pin_PB22

// These are pins not to reset.
// PA24 and PA25 are USB.
#define MICROPY_PORT_A        (0)
#define MICROPY_PORT_B        (0)
#define MICROPY_PORT_C        (0)

#define SPEAKER_ENABLE_PIN    (&pin_PA30)

// If you change this, then make sure to update the linker scripts as well to
// make sure you don't overwrite code.
#define CIRCUITPY_INTERNAL_NVM_SIZE 256

#define BOARD_FLASH_SIZE (0x00040000 - 0x2000 - CIRCUITPY_INTERNAL_NVM_SIZE)

#define CALIBRATE_CRYSTALLESS 1

// Explanation of how a user got into safe mode.
#define BOARD_USER_SAFE_MODE_ACTION "pressing both buttons at start up"

#define DEFAULT_I2C_BUS_SCL (&pin_PB03)
#define DEFAULT_I2C_BUS_SDA (&pin_PB02)

#define DEFAULT_SPI_BUS_SCK (&pin_PA05)
#define DEFAULT_SPI_BUS_MOSI (&pin_PA07)
#define DEFAULT_SPI_BUS_MISO (&pin_PA06)

#define DEFAULT_UART_BUS_RX (&pin_PB09)
#define DEFAULT_UART_BUS_TX (&pin_PB08)

// USB is always used internally so skip the pin objects for it.
#define IGNORE_PIN_PA24     1
#define IGNORE_PIN_PA25     1