Fix README

README.md

@@ -10,7 +10,7 @@ This driver is for the LS027B7DH01. It *should* work with other Sharp Mem LCD di
 ## Hookup Guide
 Connect the following pins:
 | Display |   RasPi   |
-|:------- | ---------:|
+| ------- | --------- |
 | VIN     | 3.3V      |
 | 3V3     | N/C       |
 | GND     | GND       |
@@ -23,15 +23,15 @@ Connect the following pins:
 
 ## Compile/Install the driver
 Verify that you have the linux kernel headers for your platform. For the RasPi these can be obtained by:
-`sudo apt-get install raspberrypi-kernel-headers`
+```sudo apt-get install raspberrypi-kernel-headers```
 or more generally:
-`sudo apt-get install linux-headers-$(uname -r)`
+```sudo apt-get install linux-headers-$(uname -r)```
 
 To compile the driver, run:
-`make`
+```make```
 
 To install the driver, run:
-`sudo make modules_install`
+```sudo make modules_install```
 
 If you want the module to load at boot you'll need to add it to the /etc/modules file, like:
 ```
@@ -43,17 +43,17 @@ sharp
 
 ## Compile/Install the Device Tree Overlay
 The included sharp.dts file is for the Raspberry Pi Zero W. To compile it, run:
-`dtc -@ -I dts -O dtb -o sharp.dtbo sharp.dts`
+```dtc -@ -I dts -O dtb -o sharp.dtbo sharp.dts```
 
 To load it at runtime, copy it to /boot/overlays:
-`sudo cp sharp.dtbo /boot/overlays`
+```sudo cp sharp.dtbo /boot/overlays```
 
 And then add the following line to /boot/config.txt:
-`dtoverlay=sharp`
+```dtoverlay=sharp```
 
 ## Console on Display
 If you want the boot console to show up on the display, you'll need to append `fbcon=map:10` to /boot/cmdline.txt after *rootwait*, like:
-`... rootwait ... fbcon=map:10`
+```... rootwait ... fbcon=map:10```
 
 To make sure the console fits on screen, uncomment the following lines in /boot/config.txt and set the resolution appropriately:
 ```