35 lines
1.4 KiB
C
35 lines
1.4 KiB
C
#define MICROPY_HW_BOARD_NAME "i.MX RT1020 EVK"
|
|
#define MICROPY_HW_MCU_NAME "MIMXRT1021DAG5A"
|
|
|
|
#define BOARD_FLASH_SIZE (8 * 1024 * 1024)
|
|
|
|
// i.MX RT1020 EVK has 1 board LED
|
|
// Todo: think about replacing the define with searching in the generated pins?
|
|
#define MICROPY_HW_LED1_PIN (pin_GPIO_AD_B0_05)
|
|
#define MICROPY_HW_LED_ON(pin) (mp_hal_pin_low(pin))
|
|
#define MICROPY_HW_LED_OFF(pin) (mp_hal_pin_high(pin))
|
|
#define BOARD_FLASH_CONFIG_HEADER_H "evkmimxrt1020_flexspi_nor_config.h"
|
|
|
|
#define MICROPY_HW_NUM_PIN_IRQS (3 * 32)
|
|
|
|
// Define mapping logical UART # to hardware UART #
|
|
// D3/D5 LPUART1 Not usable, Since D3 is blocked.
|
|
// D0/D1 LPUART2 -> 1
|
|
// D6/D9 LPUART3 -> 2
|
|
// D10/D12 LPUART5 -> 3
|
|
// D14/D15 LPUART8 -> 4
|
|
// A0/A1 LPUART4 -> 5
|
|
|
|
#define MICROPY_HW_UART_NUM (sizeof(uart_index_table) / sizeof(uart_index_table)[0])
|
|
#define MICROPY_HW_UART_INDEX { 0, 2, 3, 5, 8, 4 }
|
|
|
|
#define IOMUX_TABLE_UART \
|
|
{ IOMUXC_GPIO_AD_B0_06_LPUART1_TX }, { IOMUXC_GPIO_AD_B0_07_LPUART1_RX }, \
|
|
{ IOMUXC_GPIO_AD_B1_08_LPUART2_TX }, { IOMUXC_GPIO_AD_B1_09_LPUART2_RX }, \
|
|
{ IOMUXC_GPIO_AD_B0_14_LPUART3_TX }, { IOMUXC_GPIO_AD_B0_15_LPUART3_RX }, \
|
|
{ IOMUXC_GPIO_AD_B1_10_LPUART4_TX }, { IOMUXC_GPIO_AD_B1_11_LPUART4_RX }, \
|
|
{ IOMUXC_GPIO_AD_B0_10_LPUART5_TX }, { IOMUXC_GPIO_AD_B0_11_LPUART5_RX }, \
|
|
{ 0 }, { 0 }, \
|
|
{ 0 }, { 0 }, \
|
|
{ IOMUXC_GPIO_SD_B1_02_LPUART8_TX }, { IOMUXC_GPIO_SD_B1_03_LPUART8_RX },
|