1a0b4193b7
This also removes the need to pin share because we don't use the status LED while user code is running. The status flashes fallback to the HW_STATUS LED if no RGB LED is present. Each status has a unique blink pattern as well. One caveat is the REPL state. In order to not pin share, we set the RGB color once. PWM and single color will be shutoff immediately but DotStars and NeoPixels will hold the color until the user overrides it. Fixes #4133
CircuitPython Port To The Nordic Semiconductor nRF52 Series
This is a port of CircuitPython to the Nordic Semiconductor nRF52 series of chips.
Note
: There are board-specific READMEs that may be more up to date than the generic board-neutral documentation below.
Flash
Some boards have UF2 bootloaders and can simply be flashed in the normal way, by copying firmware.uf2 to the BOOT drive.
For some boards, you can use the flash target:
make BOARD=pca10056 flash
Segger Targets
Install the necessary tools to flash and debug using Segger:
note: On Linux it might be required to link SEGGER's libjlinkarm.so inside nrfjprog's folder.
DFU Targets
run follow command to install adafruit-nrfutil from PyPi
$ pip3 install --user adafruit-nrfutil
make flash and make sd will not work with DFU targets. Hence, dfu-gen and dfu-flash must be used instead.
- dfu-gen: Generates a Firmware zip to be used by the DFU flash application.
- dfu-flash: Triggers the DFU flash application to upload the firmware from the generated Firmware zip file.
When enabled you have different options to test it:
- NUS Console for Linux (recommended)
- WebBluetooth REPL (experimental)