#define MICROPY_HW_BOARD_NAME "keithp.com snekboard"
#define MICROPY_HW_MCU_NAME "samd21g18"

#define MICROPY_HW_LED_STATUS   (&pin_PA02)

#define MICROPY_HW_NEOPIXEL (&pin_PB11)

#define SPI_FLASH_MOSI_PIN          &pin_PB22
#define SPI_FLASH_MISO_PIN          &pin_PB03
#define SPI_FLASH_SCK_PIN           &pin_PB23
#define SPI_FLASH_CS_PIN            &pin_PA27

// These are pins not to reset.
#define MICROPY_PORT_A        (PORT_PB11)
#define MICROPY_PORT_B        ( 0 )
#define MICROPY_PORT_C        ( 0 )


// If you change this, then make sure to update the linker scripts as well to
// make sure you don't overwrite code.
#define CIRCUITPY_INTERNAL_NVM_SIZE 256

#define BOARD_FLASH_SIZE (0x00040000 - 0x2000 - CIRCUITPY_INTERNAL_NVM_SIZE)

#define BOARD_HAS_CRYSTAL 0

#define DEFAULT_I2C_BUS_SCL (&pin_PA08)	/* ANALOG 5 */
#define DEFAULT_I2C_BUS_SDA (&pin_PA09)	/* ANALOG 6 */

//#define DEFAULT_SPI_BUS_SCK (&pin_PB11)
//#define DEFAULT_SPI_BUS_MOSI (&pin_PB10)
//#define DEFAULT_SPI_BUS_MISO (&pin_PA12)

#define DEFAULT_UART_BUS_RX (&pin_PB08)	/* ANALOG 1 */
#define DEFAULT_UART_BUS_TX (&pin_PB09)	/* ANALOG 2 */

// USB is always used internally so skip the pin objects for it.
#define IGNORE_PIN_PA24     1
#define IGNORE_PIN_PA25     1