In general the changes are:
1. Peripheral (UART, SPI, ADC, I2C, Timer) IDs start from 1, not zero.
2. Make I2C and SPI require the ID even when there's only one bus.
3. Make I2C and SPI accept 'mode' parameter even though only MASTER
is supported.
When entering the interrupt handler of a given GPIO port, more than
one pin could have pending interrupts, therefore care must be taken
to service each interrupt one by one before leaving.
mp_obj_get_int_truncated will raise a TypeError if the argument is not
an integral type. Use mp_obj_int_get_truncated only when you know the
argument is a small or big int.
Remove unused and unneeded functions, also create Pin.get_config() that
returns the whole configuration of the pin.
This reduces code size by ~500 bytes.
While in STA mode isconnected() returns True when connected to an AP
and the IP has been acquired. In AP mode, WLAN.isconnected() returns
True if at least one connected station is present.
Each result is displayed like this:
ssid='MySSID', bssid=b'\xc0J\x00z.\xcc', security=2, channel=None, rssi=-74
The CC3200 doesn't provide channel info, that why is 'None'.
Previous to this patch the printing mechanism was a bit of a tangled
mess. This patch attempts to consolidate printing into one interface.
All (non-debug) printing now uses the mp_print* family of functions,
mainly mp_printf. All these functions take an mp_print_t structure as
their first argument, and this structure defines the printing backend
through the "print_strn" function of said structure.
Printing from the uPy core can reach the platform-defined print code via
two paths: either through mp_sys_stdout_obj (defined pert port) in
conjunction with mp_stream_write; or through the mp_plat_print structure
which uses the MP_PLAT_PRINT_STRN macro to define how string are printed
on the platform. The former is only used when MICROPY_PY_IO is defined.
With this new scheme printing is generally more efficient (less layers
to go through, less arguments to pass), and, given an mp_print_t*
structure, one can call mp_print_str for efficiency instead of
mp_printf("%s", ...). Code size is also reduced by around 200 bytes on
Thumb2 archs.
This has implications all over the place. I have to admit that
you can instantly see that usability improves, but it costs 3K.
At the same time I took the oportunity to rename the '/SFLASH'
drive to '/flash' which improves compatibility with the pyboard.
