You might wonder how this fixes a problem with PulseIn, when the
changes aren't to any of those files! PulseIn is implemented in terms of
StateMachine, which had some assumptions about the relation between
the index of a pin object in mcu_pin_global_dict_table and its "pin
number". This was true, until some pins were removed from the
microcontroller module on Pico W.
Closes: #7078
Closes: #7017
* Remove the 'GP23' alias for CYW1
* Remove the 'CYW0' alias for CYW0
* Switch VBUS_SENSE to CYW2, remove 'GP24' alias
Code that wants to use SMPS_MODE, VBUS_SENSE and LED while being
portable to the W and non-W variants should use those names, not alias
names.
* Remove A3 / VOLTAGE_MONITOR
Right now this cannot be used. The ability to check the voltage monitor
should be added back in some fashion in the future.
This also removes the need to pin share because we don't use the
status LED while user code is running.
The status flashes fallback to the HW_STATUS LED if no RGB LED is
present. Each status has a unique blink pattern as well.
One caveat is the REPL state. In order to not pin share, we set the
RGB color once. PWM and single color will be shutoff immediately but
DotStars and NeoPixels will hold the color until the user overrides
it.
Fixes#4133
This makes all the following work:
* normal microcontroller.reset()
* reset into safe mode or UF2 bootloader via microcontroller.on_next_reset()
* reset into UF2 bootloader via the "1200 baud trick"
The implementation of reset_cpu is from micropython.
The RP2040 is new microcontroller from Raspberry Pi that features
two Cortex M0s and eight PIO state machines that are good for
crunching lots of data. It has 264k RAM and a built in UF2
bootloader too.
Datasheet: https://pico.raspberrypi.org/files/rp2040_datasheet.pdf
