Boot will only run once now before USB is started. Its output goes to
boot_out.txt. After main and REPL will run with VM and hardware resets
between each.
You can either set it once up front, or set variable_frequency on custruction to
indicate that the frequency must be able to change. This informs whether a timer
can be shared amongst pins.
This also adds persistent clock calibration on atmel-samd. Once the device has
synced its clock frequency over USB it will remember that config value until USB
is used again. This helps ensure the clock frequency is similar on and off USB.
Lastly, this also corrects time.sleep() when on USB by correcting the tick counter.
The new sequence is as follows:
* Solid blue during the boot/settings script.
* Solid green during the main/code script.
* After main while waiting to enter repl or reset:
* Fading green once main is done successfully.
* On error produce a series of flashes:
* Long flash color of script.
* Long flash color of error:
* Green = IndentationError
* Cyan = SyntaxError
* White = NameError
* Orange = OSError
* Yellow = Other error
* Line number of the exception by digit. Number of flashes represents value.
* Thousands = White
* Hundreds = Blue
* Tens = Yellow
* Ones = Cyan
* Off for a period and then repeats.
At any point a write to the flash storage will flicker red.
Fixes#63
Docs are here: http://tannewt-micropython.readthedocs.io/en/microcontroller/
It differs from upstream's machine in the following ways:
* Python API is identical across ports due to code structure. (Lives in shared-bindings)
* Focuses on abstracting common functionality (AnalogIn) and not representing structure (ADC).
* Documentation lives with code making it easy to ensure they match.
* Pin is split into references (board.D13 and microcontroller.pin.PA17) and functionality (DigitalInOut).
* All nativeio classes claim underlying hardware resources when inited on construction, support Context Managers (aka with statements) and have deinit methods which release the claimed hardware.
* All constructors take pin references rather than peripheral ids. Its up to the implementation to find hardware or throw and exception.
The tick timer needed to be reworked because the ASF delay functions also
use the SysTick timer. Now, it uses TC5 and calls out to the autoreset
logic every tick. Fixes#43.
Added neopixel status colors and corrected the latch time from ms to us.
Fixes#42.
It will soft-reboot micropython after a burst of writes to the
file system. This means that after you save files on your computer
they will be automatically rerun.
This can be disabled in the build by unsetting AUTORESET_TIMER in
mpconfigboard.h.
Using the REPL will also prevent the soft resets until you reset
with CTRL-D manually.
All of the code was there except the linker was failing to clear the bss section because I added too many .zeros. The should have only been the exported globals that start with _ like _szero = .. Fixing that and turn on the usb transmit fixed everything.
Everything works fine without USB being plugged in but faults (I think) when USB is plugged in. This is switched away from the USB code from the bootloader onto the USB code thats generated by Atmel Studio using the high level classes from ASF.
