Prior to this patch Servo numbers 1, 2, 3, 4 mapped to pins X3, X4, X1, X2
on PYBLITE which doesn't match the standard PYB mapping. This patch fixes
the mapping.
The default frozen modules are no longer included (but users can still
specify their own via FROZEN_MPY_DIR), complex numbers are disabled and so
are the native, viper and asm_thumb emitters. Users needing these features
can tune the build to disable other things.
By default the firmware is built with single-precision floating point.
To build a particular board using double precision instead, put the
following line in the mpconfigboard.mk file:
FLOAT_IMPL = double
And and FLASH_FS, and use "K" values instead of hex numbers for lengths.
The increase of FLASH_TEXT is to allow more frozen bytecode for a
particular user's project. It's not used for anything else.
This method follows the new HW API and allows to set a hard or soft IRQ
callback when a Pin has a level change. It still remains to make this
method return a IRQ object.
For consistent Pin/Signal class hierarchy. With it, Signal is a proper
(while still ducktyped) subclass of a Pin, and any (direct) usage of Pin
can be replace with Signal.
As stmhal's class is reused both as machine.Pin and legacy pyb.Pin,
high/low methods actually retained there.
Prior to making this a config option it was previously available on these
(and all other) ports, and it makes sense to keep it enabled for mpy-cross
as well as ports that have a decent amount of space for the code.
Sometimes when setting a channel callback the callback fires immediately,
even if the compare register is set to a value far into the future. This
happens when the free running counter has previously been equal to what
happens to be in the compare register.
This patch make sure that there is no pending interrupt when setting a
callback.
This should be a little more efficient (since we anyway scan the input
packet for the interrupt char), and it should also fix any non-atomic read
issues with the buffer state being changed during an interrupt.
Throughput tests show that RX rate is unchanged by this patch.
The previous timeout value of 150ms could lead to data being lost (ie never
received by the host) in some rare cases, eg when the host is under load.
A value of 500ms is quite conservative and allows the host plenty of time
to read our data.
This follows the pattern of how all other headers are now included, and
makes it explicit where the header file comes from. This patch also
removes -I options from Makefile's that specify the mp-readline/timeutils/
netutils directories, which are no longer needed.
Such constants are MCU specific so shouldn't be specified in the board
config file (else it leads to too much duplication of code).
This patch also adds I2C timing values for the F767/F769 for 100k, 400k
and 1MHz I2C bus frequencies.
