If a board needs these outputs then it can define MICROPY_HW_CLK_PLLQ/R.
It saves power to not enable them if they are not needed.
Signed-off-by: Damien George <damien@micropython.org>
Supported from GCC 8 and up, and Compiler Explorer suggests it works as
expected with Clang since 3.6 (2014).
- Fixes situation where building embedded MicroPython with -O0 and
MICROPY_NLR_X64 crashes at runtime (due to nlr_push pushing the
frame pointer register EBP). Closes#12421.
- Allows removing the macOS tweak to undo pushing EBP onto the stack
in the generated function prelude.
Signed-off-by: Angus Gratton <angus@redyak.com.au>
Currently, check_esp_err() raises an exception without a location in the
source code, eg:
Traceback (most recent call last):
File "<stdin>", line 8, in <module>
OSError: (-258, 'ESP_ERR_INVALID_ARG')
This commit allows additional error reporting (function, line and file) to
be enabled via detailed exceptions. Change the error reporting config to
#define MICROPY_ERROR_REPORTING (MICROPY_ERROR_REPORTING_DETAILED)
and then exception messages from IDF errors look like:
Traceback (most recent call last):
File "<stdin>", line 1, in <module>
OSError: (-258, "0x0102 ESP_ERR_INVALID_ARG in function 'set_duty_u16'
at line 342 in file './machine_pwm.c'")
Signed-off-by: Ihor Nehrutsa <IhorNehrutsa@gmail.com>
Before, incorrect use when calling a core function would just say
"extra keyword arguments given"; now, it will name the argument:
```python
>>> Synthesizer(bad_kwarg="boo")
TypeError: unexpected keyword argument 'bad_kwarg'
```
Fixes are:
- Reset the module first before changing GPIO1 direction.
- Skip spurious bytes received after reset.
- Use HCI UART ID and baudrate when reinitializing UART.
- Disable all printf output which causes unit-tests to fail.
Signed-off-by: iabdalkader <i.abdalkader@gmail.com>
Fixes are:
- The baudrate argument is a keyword arg, it was passed before as a
positional arg.
- Use the port and baudrate arguments passed from higher level code instead
of the hard-coded port ID and baudrate, which would allow HCI drivers to
change baudrates.
- Increase UART char timeout and RX buffer size.
Signed-off-by: iabdalkader <i.abdalkader@gmail.com>
with the i2c bus operating at 400kHz this achieves a 4.8kHz SPI clock
rate which could be worse.
It accepts the same style of init sequence as displayio.
tested by scoping the pins on the espressif lcd dev kit with a dummy init sequence:
```python
dotclockframebuffer.ioexpander_send_init_sequence(
bus=bus,
i2c_address=expander_addr,
gpio_address=1,
gpio_data_len=1,
gpio_data=0xff,
cs_bit=1,
mosi_bit=3,
clk_bit=2,
init_sequence=init_sequence)
```
Jeff Epler
Damien George
Angus Gratton
Dan Halbert
Scott Shawcroft
Dan Halbert
IhorNehrutsa
iabdalkader
Wind-stormger