this has the side effect of making some notes more accurate, the new
frequency= value in the test is closer to the true midi frequency of
830.609...Hz.
This class allows much more expressive sound synthesis:
* tremolo & vibrato
* arbitrary frequency
* different evelope & waveform per note
* all properties dynamically settable from Python code
this allows to test how the midi synthesizer is working, without access
to hardware. Run `micropython-coverage midi2wav.py` and it will create
`tune.wav` as an output.
This works for me (tested playing midi to raw files on host computer, as
well as a variant of the nunchuk instrument on pygamer)
it has to re-factor how/when MIDI reading occurs, because reasons.
endorse new test results
.. and allow `-1` to specify a note with no sustain (plucked)
In contrast to MidiTrack, this can be controlled from Python code,
turning notes on/off as desired.
Not tested on real HW yet, just the acceptance test based on checking
which notes it thinks are held internally.
* Enable dcache for OCRAM where the VM heap lives.
* Add CIRCUITPY_SWO_TRACE for pushing program counters out over the
SWO pin via the ITM module in the CPU. Exempt some functions from
instrumentation to reduce traffic and allow inlining.
* Place more functions in ITCM to handle errors using code in RAM-only
and speed up CP.
* Use SET and CLEAR registers for digitalio. The SDK does read, mask
and write.
* Switch to 2MiB reserved for CircuitPython code. Up from 1MiB.
* Run USB interrupts during flash erase and write.
* Allow storage writes from CP if the USB drive is disabled.
* Get perf bench tests running on CircuitPython and increase timeouts
so it works when instrumentation is active.
cpython actually makes sure the newly chained exception doesn't create
a cycle (even indirectly); see _PyErr_SetObject use of "Floyd's cycle
detection algo". We'll go for the simpler solution of just checking
one level deep until it's clear we need to do more.
Closes: #7414
\r\n files must be working due to micropython's built in handling of
text-mode files, I didn't implement it.
\r-only (old mac text-mode files) are explicitly not supported by
the toml format.
While working on adding 0o and 0b literals (which aren't added yet and
may not be) I realized that my approach would likely cause a problem
for the value "0"
* use a virtual fat filesystem during the test
* this makes the file I/O part more closely patch runtime which is nice
* side-steps the need to add a special function for testing
* but test still can't be run on a device, because the vfs calls
are incompatible, and you intentionally can't remount "/" anyway
* and side-steps problems with storing 'bad' toml files
Jeff Epler
Scott Shawcroft
Dan Halbert
hathach
Mark
gamblor21
MicroDev