The DFU bootloader on the ST32F7 chip changes the clocksource
for various possible boot sources (UART1, UART3, I2C1-3).
This commit resets those clock sources back to their cold
reset values.
USB serial is now working for F7.
Internal file storage is now working for F7. The flash is laid out a bit
differently to the F4 - 4 x 32K, 1 x 128K with the rest 256K, so the
internal storage is 96K.
Added more pind definitions for STM32F7DISC board. Made USART1 be the
default HWUART repl. The STLINK usb connector also looks like a USB
serial port which is attached to USART1 on the STM32F7DISC.
Extracted GPIO clock enable logic into mp_hal_gpio_clock_enable
and called from anyplace which might need to use GPIO functions
on ports other than A-D.
Thanks to Dave Hylands for the patch.
All files were converted to linux line endings.
All trailing whitespace was removed using:
for f in f7/inc/* f7/src/*; do sed --in-place 's/[[:space:]]\+$//' $f; done
All non-ascii chars in comments were replaced with ascii equivalents or
removed.
This is how the names will be printed on the sticker that goes on top
of the EMI shield. The shorter names also help saving a few bytes of
RAM and ROM.
Previous to this patch there were some cases where line numbers for
errors were 0 (unknown). Now the compiler attempts to give a better
line number where possible, in some cases giving the line number of the
closest statement, and other cases the line number of the inner-most
scope of the error (eg the line number of the start of the function).
This helps to give good (and sometimes exact) line numbers for
ViperTypeError exceptions.
This patch also makes sure that the first compile error (eg SyntaxError)
that is encountered is reported (previously it was the last one that was
reported).
When looking to see if the REPL input needs to be continued on the next
line, don't look inside strings for unmatched ()[]{} ''' or """.
Addresses issue #1387.
ViperTypeError now includes filename and function name where the error
occurred. The line number is the line number of the start of the
function definition, which is the best that can be done without a lot
more work.
Partially addresses issue #1381.
The adapter class "TelnetToSerial" is used to access the Telnet
connection using the same API as with the serial connection. The
function pyboard.run-test() has been removed to made the module
generic and because this small test is no longer needed.
When looking for chars to indicate raw repl is active, look for the full
string of chars to improve reliability of entering raw repl correctly.
Previous to this patch there was the possibility that raw repl was
entered in a dirty state, where not all input chars from previous
invocation were drained.
blmorris
Damien George
Dave Hylands
Daniel Campora
Paul Sokolovsky
Tom Soulanille