From 3452ee58d36a1d6ae2c156c84903b84131d00a8b Mon Sep 17 00:00:00 2001 From: Damien George Date: Thu, 9 Jun 2022 12:23:07 +1000 Subject: [PATCH] stm32/boards/LEGO_HUB_NO6: Add comment to readme about powering off. Signed-off-by: Damien George --- ports/stm32/boards/LEGO_HUB_NO6/README.md | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) diff --git a/ports/stm32/boards/LEGO_HUB_NO6/README.md b/ports/stm32/boards/LEGO_HUB_NO6/README.md index 7d5f2a416c..376d0f2b0e 100644 --- a/ports/stm32/boards/LEGO_HUB_NO6/README.md +++ b/ports/stm32/boards/LEGO_HUB_NO6/README.md @@ -33,7 +33,8 @@ Backing up original Hub firmware Before install MicroPython it is advised to backup the original LEGO firmware that the Hub comes installed with. To do this, enter the built-in bootloader by holding -down the Bluetooth button for 5 seconds while powering up the Hub via USB. Then +down the Bluetooth button for 5 seconds while powering up the Hub via USB (you may +need to take out the battery and disconnect USB to power off the Hub first). Then run the following command from the root of this repository: $ cd ports/stm32 @@ -58,7 +59,8 @@ the root of this repository run: $ make BOARD=LEGO_HUB_NO6 Now enter the built-in bootloader by holding down the Bluetooth button for 5 -seconds while powering up the Hub via USB. Then run: +seconds while powering up the Hub via USB (you may need to take out the battery +and disconnect USB to power off the Hub first). Then run: $ make BOARD=LEGO_HUB_NO6 deploy