circuitpython/ports/broadcom/config.txt


# dtparam=audio=on
# dtoverlay=dwc2
# core_freq_min=500
gpio=22-27=np
enable_jtag_gpio=1
# hdmi_group=1
# hdmi_mode=16
gpu_mem=16
kernel_address=0x100000
Initial broadcom port for Raspberry Pi This targets the 64-bit CPU Raspberry Pis. The BCM2711 on the Pi 4 and the BCM2837 on the Pi 3 and Zero 2W. There are 64-bit fixes outside of the ports directory for it. There are a couple other cleanups that were incidental: * Use const mcu_pin_obj_t instead of omitting the const. The structs themselves are const because they are in ROM. * Use PTR <-> OBJ conversions in more places. They were found when mp_obj_t was set to an integer type rather than pointer. * Optimize submodule checkout because the Pi submodules are heavy and unnecessary for the vast majority of builds. Fixes #4314 2021-08-04 19:27:54 -04:00
			`# dtparam=audio=on`
			`# dtoverlay=dwc2`
			`# core_freq_min=500`
			`gpio=22-27=np`
			`enable_jtag_gpio=1`
			`# hdmi_group=1`
			`# hdmi_mode=16`
			`gpu_mem=16`
raise kernel load addr and slip stack under kernel on both 32bit and 64bit 2023-08-21 16:47:10 -04:00			`kernel_address=0x100000`