diff --git a/gallery/readme.md b/gallery/readme.md
index 7930cf4..e9ea633 100644
--- a/gallery/readme.md
+++ b/gallery/readme.md
@@ -1,40 +1,30 @@
# A gallery of projects made with NopSCADlib
-
## ArduinoThermostat
Arduino thermostat to control a beer fridge to use it as an environmental chamber.
![](ArduinoThermostat.png)
-
-
## EnviroPlus
Environmental monitor using Enviro+ sensor board and a Raspberry Pi Zero.
![](EnviroPlus.png)
-
-
## FilamentDryBox
A small fan oven with a spool holder to keep the filament warm and dry.
![](FilamentDryBox.png)
-
-
## HydraBot
Current state of HydraRaptor after being modified for laser engraving.
![](HydraBot.png)
-
## IOT 50V PSU
WiFi controllable PSU
![](IOT_50V_PSU.png)
-
-
## Lab ATX PSU
Bench power supply built around an ATX PSU.
@@ -47,15 +37,11 @@ Bench power supply built around an ATX PSU.
-
-
## Laser Load
15kV dummy load for testing CO2 laser PSUs
![](Laser_load.png)
-
-
## MainsBreakOutBox
13A socket break out box with 4mm jacks to measure voltage and / or load current and earth leakage current.
@@ -72,8 +58,6 @@ Earth leakage can be measured Canadian CSA style by disconnected the neutral lin
![](MainsBreakOutBox.png)
-
-
## Mains Box
Mains isolated and variable supply with metering.
@@ -81,15 +65,11 @@ Mains isolated and variable supply with metering.
-
-
## SunBot
A solar tracker to keep a solar panel pointing at the sun.
![](SunBot.png)
-
-
## Turntable
WiFi enabled remote control turntable for photography
@@ -97,8 +77,6 @@ WiFi enabled remote control turntable for photography
Was actually made from DiBond but shown made with carbon fibre here.
-
-
## Variac
Motorised variac with WiFi control, see [hydraraptor.blogspot.com/2018/04/esp8266-spi-spy](https://hydraraptor.blogspot.com/2018/04/esp8266-spi-spy.html)
@@ -106,4 +84,3 @@ Motorised variac with WiFi control, see [hydraraptor.blogspot.com/2018/04/esp826
-
diff --git a/scripts/gallery.py b/scripts/gallery.py
index 812f774..c0fcc83 100755
--- a/scripts/gallery.py
+++ b/scripts/gallery.py
@@ -68,9 +68,10 @@ def gallery(force):
match = re.match(r"^(#+).*$", line)
if match:
line = '#' + line
- if line == '---\n':
- break;
- print(line[:-1], file = output_file)
+ if line == '---\n' or line == '\n':
+ break
+ if line != '\n':
+ print(line[:-1], file = output_file)
else:
print(Fore.MAGENTA + "Can't find", document, Fore.WHITE);
with open(target_dir + "/readme.html", "wt") as html_file: